rnFor four years, Brent Schmitz tried to make strip-till work with little success. "We'd run the strips in the fall, but then in the spring, we could never see where we'd been."rnLooking for a strip-till tool with a residue manager, Brent tried the Yetter 2984 Maverick™ HR Plus® wi...e."rn
In most conditions, mount the wheels offset in the front hole and rear hole. In some conditions, the wheels perform best when mounted in one front hole and one middle hole.
With the 2968 Dual Fertilizer Opener, Yetter brings growers one of the most flexible fertilizer openers on the market. Delivers consistent placement on both sides of the row.
rnMike Marquardt purchased Yetter 2967 residue managers with the Screw Adjust feature, setback kits, and SharkTooth® wheels for his John Deere 1750 6-row planter. The setback kits made it possible for Mike to continue using his frame-mounted coulters. "Without the kit, my coulters would ...s."rn
Yes, you can do whichever best fits your operation. If you take the seal out, you must grease every 50 hours. If you leave the seal intact, fill the wheel assembly with grease before using. No need to grease again until you replace the bearing.
Replace your planter's rubber ring with the Yetter 6200-008 Twister Short Poly Ring. Designed for shallow-planted crops like sugar beets, cotton, and canola.
Hello from YetterCo.com! This website uses cookies.
We use cookies to continuously improve our services and visitor experience. Additionally, we set cookies for visitors on social media sites to track performance. By continuing on this website or clicking "Ok" we will assume that you have read this information and consent to receive cookies on our website. For more information visit our website's Privacy Policy.